•Solar wind turbine consists of a collector 1, a chimney 2 (in which the wind turbine rotor 27 and the electric generator 32 are located), and a cap 3.

• Collector 1 is consisted of upper central glass part 4, and a lower peripheral transparent plastic part 5.

•The lower part 5 of the collector 1 consists of at least four plastic sectors 19, with the same number of sectors 19 of the upper 4 and lower part 5 of the construction. Sectors 19 of the lower part 5 put together form a cylinder (not numbered in the blueprint drawings) which ends in the form of partial shell of a truncated square pyramid (not numbered in the blueprint drawings). Every sector 19 of the lower part 5 has a transparent plastic roof 20 made of PVC, Lexane, or Graphene, with the reinforcement along the edges, while the roof planes 20 can be partially rotated around µ, η, ξ axes, and can be lifted with the cable system 23 figure: FIG 8. Roofs 20 are supported with partition walls 21, which have their own fundament 22, and with thermo accumulation slopes 7, form sectors 19 which, all together aligned in circle, form a collector lower part 5. Sectors 19 in the drawings are denoted by the cardinal points, namely, by the initials of the cardinal and intermediate directions in the collectors with eight sectors: 19N, 19NI, 19I, 19SI, 19S, 19SW, 19W, 19NW. Walls 21 and slopes 7 accumulate the sun's heat, and then emit it at night or at a sudden drop in temperature. Electric- generator 32 is located in the space 10 which is under the rotor 27. Underneath the lower part of the chimney 2, the cyllindrical arrea 9 continues, in which the elevator (not numbered in the blueprint drawings) is optionally placed. Valve 8 is also located in the space 9, and it can take two positions, first (I) in the upper, and second (II) in the lower part of the area9. Area 9 is connected to every segment of sector 19 of the lower part 5 of the collector 1 by underground pipes 6. In the centre of collectors  lower part 5, the inner cilindrical openning is located (not numbered in the blueprint drawings), that goes all the way through the collectors lower part 5, which contains the glass part 4, with spiral intakes (a space between spiral walls 18), as the extensions of sectors 19. The upper part 4 of the collector 1 consists of at least four or more sectors (not numbered in the blueprint drawings) in continuation from the sector 19, that are all together aligned to form the cylinder 4. The upper side of the cylinder 4, forms a shell shaped as truncated cone (not numbered in the blueprint drawings), with inner cylindrical opening (not numbered in the blueprint drawings), in the centre of the upper part 4, of the collector 1, and passes through entire height of the upper part, with same diameter as wider part 26, of the chimney 2.